Power connection – McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 User Manual
Page 351
Advertising
B-5
Connecting the UltraNet Edge 3000
Power Connection
Use the following procedure to connect power to the UltraNet Edge
3000:
NOTE:
The illustration (see Figure B-2) depicts the redundant power supply.
1. Connect the appropriate end of both AC power cords to the
power connectors on the rear panel of the UltraNet Edge 3000
unit.
2. Connect the three-pronged (NEMA 5-15P) end of the power cord
to a grounded AC outlet.
CAUTION
Do not plug both power cords in the same outlet. Make sure that
each outlet has its own circuit.
Figure B-2
Connecting Power Cords to Rear Panel of UltraNet Edge 3000
Sb033
Advertising