McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 373)

D-1
D
Advanced UCM
Configurations
This appendix provides additional UltraNet ConfigManager (UCM)
configuration options that are beyond the typical Edge network
configurations. The topics covered are as follows:
• Configuring the Internal McDATA Fibre Channel Switch
Interface
• Time Synchronization Protocol
• Transport CRC Checking
• E_Port Disk Streaming Settings
• F_Port Disk Streaming Settings
Configuring the Internal McDATA Fibre Channel Switch Interface
The following section pertains to F_port configurations and is only
necessary to configure when using the UltraNet Edge 3000 internal
Fibre Channel Switch (FCSW) application.
The Fibre Channel Switch Interface dialog box appears when you
double-click on a Fibre Channel Switch interface
, or when you
press Finish and Show I/F on the Create Data Paths dialog box when
creating a Fibre Channel Switch connection data path. Use this dialog
box to configure the selected Fibre Channel Switch interface.