McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 39)

1
Introduction 1-7
UltraNet Edge 3000 Security
UltraNet Edge 3000 Security
The UltraNet Edge 3000 is shipped with a default password. For
security purposes you will need to change the default to your own
password. Use the following procedure to change or disable the
UltraNet Edge 3000 password.
1. Telnet into the UltraNet Edge 3000 box.
2. When prompted for the password, enter the default password
(password).
3. To change the default, enter the system passwd command at the
prompt.
tm.0x10> system passwd
4. Enter the old password when prompted (the default is
password ).
5. You will then be prompted for your new password, type and then
retype the same password to confirm. The password is not echoed
to the screen.
A password may contain 1->39 characters. You may disable the
password by pressing the Enter key twice when prompted for the
new password.