McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 - Manual (Page 82)

5
5-6 McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
UltraNet ConfigManager automatically assigns a name and
number to each icon that represents the UltraNet Edge 3000, for
example Node10 and Node20. The node icons and their
corresponding names are also displayed under the NetMap1
heading in the TreeView Area on the left.
Setting the Initial
Configuration If you configured an UltraNet Edge 3000 custom chassis (in Chapter
4), continue the configuration process with the “Setting the Initial
Configuration” procedure.
NOTE: When you are performing this part of the configuration, the PC
which has UltraNet ConfigManager installed on it, must be attached to the
same subnet as the UltraNet Edge 3000 Ethernet maintenance interface. If this
is not possible, refer to the “Manual Configuration of the Initial IP Settings”
procedure in Appendix H.
1. Right click on Node10 and select Set Initial Config from the
menu that appears.
Network Map Area
(Click here twice to place
two nodes in the map)