M-AUDIO Fast Track Pro - Manual (Page 13)

Fast Track Pro User Guide
11
English
Selecting Your Outputs
The Fast Track Pro’s outputs are selected in the Control Panel’s Bandwidth page (see Section 7).
Signals routed to Outputs 1 and 2 in your DAW application will appear at the rear-panel TRS Outputs 1 and 2, and be duplicated at
unbalanced Outputs 1 and 2.
When Outputs 3 and 4 are activated, they will show up as output channels in your DAW application. Signals routed to Outputs 3 and 4
in your DAW application will appear at the S/PDIF outputs, and be duplicated at unbalanced Outputs 3 and 4.
The level to the analog outputs is controlled by the main output level control.
Headphone Monitoring
The A/B button selects the output source sent to the front-panel headphone output. In the A (out) position, the main line output signal
(Outputs 1 and 2) is sent to the headphone outputs. In the B (in) position, the S/PDIF output signal (Outputs 3 and 4) is sent to the
headphone outputs.
The headphone output level is controlled by the Level control knob. This output level is independent of the main output level.
Stand-alone Mode
The Fast Track Pro can act as a stand-alone mic preamp with 24-bit/44.1kHz A/D converters. Inputs 1 and 2 are sent to the S/PDIF Out
and analog Outputs 3 and 4 post inserts.
9 › Warranty Terms & Registration
Warranty Terms
M-Audio warrants products to be free from defects in materials and workmanship, under normal use and provided that the product is
owned by the original, registered user. Visit www.m-audio.com/warranty for terms and limitations applying to your specific product.
Warranty Registration
Thank you for registering your new M-Audio product. Doing so immediately both entitles you to full warranty coverage and helps M-
Audio develop and manufacture the finest quality products available. Register online at www.m-audio.com/register to receive FREE
product updates.
FastTrack Pro
Tested to comply with
FCC standards
FOR HOME OR STUDIO USE