Marmitek EasyTouch35 - Manual (Page 12)

12 MARMITEK
6. Display will show the Search Setup Screen. Press the
Touchscreen "UP" key (or Power or Play) repeatedly until
the Device to be controlled changes channel.
Alternatively, you can use the Channel Up key. Press and
release the Touchscreen "OK" (or Mute) key to install the
Code. Display will return to the Main Setup Screen.
If you accidentally overshoot the Code required, press the
Touchscreen "DOWN" or Channel Down to backtrack
through the Library to return to the correct code. Pressing
the Touchscreen "UP" key (or Power or Play) will change
direction to forward again.
7. Repeat this procedure for any other appliance you want
to control (TV, VCR, DVD, SAT, CD, CBL, AUDIO and
Marmitek X-10 Home Automation).
8. The Code Search Method entry is now complete. Press
and release the Touchscreen "EXIT" key to return to
normal operation.
Notes:
a.
When all codes have been searched the LED will "error" flash indicating end of
search and Main Setup Screen will be displayed.
b. The above search procedure assumes that you want to store VCR codes under the
VCR key, Cable codes under CBL, etc. If you want, for example, to store a VCR code
under CBL, etc., then the Mode key must be "primed" for the new appliance. First
follow the "Programming using 3 Digit Code Table" procedure and then enter any
VCR code prior to carrying out the above search steps.
c. If the Device does not have a Channel Up key, use the Play (VCR & CD/Audio only) or
the Power keys instead.
d. Code Search will start from the currently stored three digit number under that Mode
e.g. if the Mode has 100 codes and the currently stored code is 050 then the Code
Search will start from 051 continuing to 100 before looping back to 000 and finishing
at 050. This simplifies the search process by allowing you to bypass codes already
tried.
9 Identifying codes found using the
search procedures
1. Press and hold Setup key until the LED remains on
(occurring after approximately 2-3 seconds) and display
will show the Main Setup Screen.
2. Release Setup key.
3. Press and release the Touchscreen "CODE" Key.
easytouch35_manual ok 6/17/03 10:30 AM Page 12