Marmitek EasyTouch35 - Manual (Page 14)

14 MARMITEK
4. The Macro Setup Digit Screen will be shown. Press and
release the digit key the Macro
is to be stored under.
5. The Macro Mode Setup Screen
will be shown. The first key
stored in a Macro must be a
Mode key. Press and release
desired Mode key (TV, VCR,
SAT, etc.) on the rubber
keypad.
6. Display will show the Macro
Key Setup Screen. This screen
comprises the current screen labels for that Mode plus the
SETUP and MACRO Touchscreen labels will be shown. Press
and release the remote keys (maximum of 20) that are
required to be stored in the exact order that they should
be transmitted. Use the Touchscreen "SCREEN" key to
toggle the screen keys displayed and use the Mode keys
for any Mode changes. The Setup key can be used to add
delays – see separate notes. These are all counted as
keystrokes.
7. To store the Macro, press and release the rubber
"MACRO" Key. Display will return to the Main Setup
Screen. Note - if you program the maximum of 20 keys,
then the Macro will be automatically stored on the 20th
keypress.
8. Macro key programming now completed. Press and release the Touchscreen "EXIT"
key to return to normal operation.
Macro Notes:
1. "SHIFTED" key commands are not allowed to be included in Macros.
2. There is an automatic delay of 0.5 second between each IR transmission in the
sequence.
3. It may be necessary to have "delays" included in the Macro sequence (e.g. to allow
your TV warm-up time). Pressing the Setup key can include delays. The display will
show the Macro Delay Setup Screen for digit selection. Press the digit for the required
delay (in seconds) e.g. to enter a delay of 4 seconds, press and release Setup followed
by 4. The maximum delay is 9 seconds. An "EXIT" key entry will give the default
0.5second delay. A delay is counted as one keystroke.
easytouch35_manual ok 6/17/03 10:30 AM Page 14