Marmitek EasyTouch35 - Manual (Page 16)

16 MARMITEK
4. Display will show the "P<P1" Mode Setup Screen. Press
and release desired Mode key (TV, VCR, SAT, etc.) on the
rubber keypad.
5. Display will show the "P<P2"
Setup Screen. This screen
comprises the current screen
labels for the Mode plus the
SETUP and "P<P" Touchscreen
labels will be shown. You can
now press up to 3 keys (a
minimum of 1 key must be
pressed). Use the "SCREEN"
Key to toggle the screen keys
displayed – this counts as a
keypress. When 3 keys are
entered you will automatically
continue to Step 6. If less than
3 keys are required then press the Mode key and go
directly to Step 7.
6. To enter the second set of data, press and release desired
Mode key (TV, VCR, SAT, etc.) on the rubber keypad. Display will again show the
"P<P2" Setup Screen.
7. You can now press up to 3 keys (a minimum of 1 key
must be pressed) for the second set of data. Use the
"SCREEN" Key to toggle the screen keys displayed – this
counts as a keypress. When 3 keys are entered you will
automatically continue to Step 8. If less than 3 keys are
required then press the Setup key and go directly to Step
8.
8. Display will return to the Main Setup Screen. Channel
Toggle "P<P" setting routine now complete. Press and
release the Touchscreen "EXIT" key to return to normal
operation.
9. To activate the Channel-Toggle function, Press and release
the Touchscreen "P<P" key repeatedly to alternate
between the two sets of data you entered.
easytouch35_manual ok 6/17/03 10:30 AM Page 16