Marmitek EasyTouch35 - Manual (Page 23)

23 EASYTOUCH 35
15 Extra functions:
1. Keypress Acknowledge Beep Feature:
It is possible to get an audible feedback of key-presses. When any key is pressed, the
remote will generate a beep acknowledging the keypress. The Keypress Acknowledge
feature can be toggled on or off as follows:
1. Press and hold Setup key until the LED remains on (occurring after approximately 2-3
seconds) and the Main Setup Screen is shown.
2. Release Setup key.
3. To disable the beep, press and hold the rubber Stop key until the LED blinks. To
enable the Beep, press and hold the rubber Play key until the LED blinks.
4. Beep Feature now toggled On or Off and the Main Setup Screen is shown.
2. Touchscreen Panel On-Time:
The Touchscreen Panel display will remain on for a User selectable time period (10, 20,
30,……90 seconds). Power-on default is 10 seconds from last keypress. To set the
Touchscreen/Light On time:-
1. Press the TV key
2. Press and hold Setup key until the LED remains on (occurring after approximately 2-3
seconds) and the Main Setup Screen is shown.
3. Release Setup key.
4. Press and release the Setup key. The LED will blink to acknowledge the keypress and
the "9" Digit Setup Screen will be shown.
5. Press and release a digit key 1-9 (1=10 seconds, 2=20seconds, etc) followed by
ENTER. The LED will blink to acknowledge the keypress and the display will return to
the Main Setup Screen.
6. Touchscreen On time setting now complete.
3. User Master Reset:
To reset the remote defaults back to factory settings.
1.
Press and hold Setup key until the LED remains on and display shows the Main Setup
Screen.
2. Release Setup key.
3. Press and hold the Setup key for approximately 5 seconds until the LED blinks on then
turns off.
4. Default Reset now complete and remote will be in normal TV Mode.
4. Channel Scan/Search Key (Touchscreen):
The Channel Scan/Search function is only available in TV, DVD, CBL/SAT and CD/Audio
Modes. Pressing the Touchscreen "SEARCH" Key allows the User to sequentially scan up
available program channels. This key cannot be learned.
When pressed, a Channel Up command for the Current Mode code is sent once every 3
seconds. When any other key is pressed the scan will stop. Scanning will automatically
time-out after 2 minutes if no key is pressed.
ENGLISH
easytouch35_manual ok 6/17/03 10:30 AM Page 23