Marmitek EasyTouch35 - Manual (Page 8)

8 MARMITEK
1. The remote must be in TV Mode with the "second" display screen being shown.
2. Press and hold the Touchscreen "SLEEP" Key until the LED remains on (occurring after
approximately 2-3 seconds) and display will show the Sleep Setup Screen.
3. Release the "SLEEP" key.
4. Press and release the numeric keys (01-99) for the time required. The LED will blink
off to indicate keypress acceptance and the remote display will return to normal
operation.
5. TV Sleep Timer now set. Leave the Remote pointing towards the TV with an
unobstructed path.
To cancel the Sleep Timer, press and release the Power key in TV Mode or press and hold
the SLEEP key until the remote beeps twice.
Programming the ET35
You program the ET35 using the Setup key and following the procedures below. Each
keypress is acknowledged with an LED blink and a beep from the sounder. 3 LED blinks
and sounder beeps indicate an incorrect or invalid entry.
Attention: You always need to activate the touch screen remote control by
touching the screen before you can start the described proocedure.
6 Programming using 3 Digit Code Tables for the
TV, VCR, CD, SAT, CBL, DVD, AUDIO and Marmitek
X-10 Home Automation keys
Note: you can dedicate any appliance (TV, DVD, SAT...) to the VCR, DVD, SAT, CD, AUDIO,
CBL and Marmitek X-10 Home Automation keys: you need first to enter the 3 digit code
of the appliance you wish to control (found in the code book). In any case, follow the
method below:
1. Make sure your appliance is
switched on (for example TV)
2. Activate your ET35 remote by
touching the screen
3. Press and hold the Setup key
until the LED remains on
(occurring after approximately
2-3 seconds) and display
shows the Main Setup Screen.
4. Release Setup key.
5. Press and release the
Touchscreen "CODE" Key.
6. Display will show the Mode
Setup Screen. Press and release
desired Mode key (TV, VCR,
SAT, etc.) on the rubber
keypad.
easytouch35_manual ok 6/17/03 10:30 AM Page 8