Minolta DI2510 - Manual (Page 27)

3 3.1 Installation Precautions
3-2 Di2010/Di2510/Di3010/Di3510
P
rec
auti
on
s
Chap
ter
3
3.1 Installation Precautions
Installation Site
To ensure utmost safety and prevent possible malfunctions, install the copier in a
location that meets the following requirements.
-
A location away from curtains, etc. that may catch fire and burn easily
-
A location that is not exposed to water or other liquids
-
A location free from direct sunlight
-
A location out of the direct airflow of an air conditioner or heater, and not
exposed to extremely high or low temperatures
-
A well-ventilated location
-
A location that is not exposed to high humidity
-
A location that is not extremely dusty
-
A location not subjected to undue vibrations
-
A stable and level location
-
A location where ammonia or other organic gases are not generated
-
A location that does not put the operator in the direct airflow of exhaust from the
copier
-
A location that is not near any kind of heating devices
Power Source
The power source requirements are as follows.
● Voltage fluctuation: Maximum ±10% (127 V: +6%, –10% )
● Frequency fluctuation: Maximum ±0.3 Hz
❍ Use a power source with as little voltage or frequency fluctuations as possible.