Marvin Window - Manual

Window Installation
StormPlust and Structural Installations
19970019
2013−03−01
These instructions are applicable for the following StormPlus products:
Clad Ultimate Casement 1 Wood Ultimate Casememt 1
Clad Ultimate Double Hung (CUDH) 2 Wood Ultimate Double Hung (WUDH) 2
Clad Direct Glaze Polygon/Round Top Wood Direct Glaze Polygon/Round Top
Clad Ultimate Double Hung Magnum Wood Ultimate Double Hung Magnum
1 Includes Awning, Operator, Picture 1,, Stationary 3/4,, Round Top Operator, and Round Top Stationary.
2 Includes Picture, Transom, Round Tops and Polygon
ABSTRACT
These instructions advise the window installer/carpenter/contractor on the recommended way to install Marvin
windows where structural installation is necessary, including those rated for use in Impact Zones 2 and 3. Exact
installation methods for Impact Zone 4 windows are NOT included. Instead, refer to the Notice of Acceptance (see
details inside).
In addition to steps for installing your window, included within are: Rough opening (RO) preparation for recessed
masonry applications; RO prep and sealing details for standard wood frame construction; detailed fastening
methods and more.
The procedures within these instructions are consistent with those used in testing to achieve the advertised DP
rating. Contact your local Marvin dealer if your construction scenario differs from those detailed within.
Regional standard practices, environmental conditions and codes may vary and supersede the
procedures contained within. The responsibility for compliance is yours: the installer, inspector, and
owner(s). See the Technical Installation Specifications inside for more details.
These instructions are applicable for the following Structural installations:
Clad Ultimate Double Hung Magnum Wood Ultimate Double Hung Magnum
NOTE: Certified IZ2 and IZ3 Ultimate Casement, Ultimate Double Hung, and Direct Glaze Polygon/
Round Top units must be installed using jamb screws or structural brackets. Certified IZ3 Ultimate
Double Hung Magnum units must be installed using the jamb screw method only.