MRV Communications EM316EDFA-BR - Manual (Page 39)

Fiber Driver
®
EM316EDFA User Guide
P/N 1294008-001 Rev D2
30
5.2.6.3 “show”
The show command displays management and system information related to the
EM316LNXNM-OT management module, the hosting chassis, other modules in the chassis,
and ports available within the managed system. The arguments (parameters) following the
show
command and the operational context displayed by the system prompt control the
many functions available through this command.
The box below illustrates the show command. The help “?” is applied first, then the command
is used with no arguments in the port context of an EDFA module.
The CLI help for the show command is identical in the port-level context and the slot-level
contexts. Refer to the Slot-Level Commands section for “show?” and “show ?” information.
fiberdriver(port/1.3.1)# show
Port: 1.3.1
Name: FO_SC at 1.3.1
Enable: enable
Link: no Signal
Connector: fo SC Medium: single Mode
TxPower(dBm): -15.26
DDiags: Alarm Temp(C): 23 Supply(V): 3.28
Alarm Cause: TX Loss of Signal Alarm (tx -15.26dBm)
Gain desired(dB): 25
Gain(dB): 25.69
fiberdriver(port/1.3.1)#