Motorola RDM2020 - Manual (Page 41)

BA
SIC
C
O
NFIGURA
TION
English 33
4. Use button B to move the cursor to the left.
5. When the cursor is located in the first character,
the radio produces a bonk tone.
6. Use the / buttons to change the current
selected character to the next ASCII value in
alphabetical order (from A to Z). The characters
will be uppercase letters.
To toggle character between uppercase and
lower case, press the A button. The supported
lower case characters are:
b, c, d, g, h, i, l, o, r, u.
To insert special characters press the C
button.The supported special characters and
numbers are shown in the following order: 0 - 9
* {}? &%. + / - _ ' ' \. Character (' ') is a used for
blank spaces.
Note: If the radio is left idle for more than 3
seconds, the current character will be
accepted and the cursor will advance one
space to the right.
7. Long press the PTT button to save and go back
to the “Channel Aliasing Selection Mode” to edit
other channel alias name, -- or --
Turn OFF the radio to exit without saving
changes.
Notes: If the channel alias name is left blank, the
radio will play a bad key chirp and will stay
in the editing menu mode until the channel
name is edited and saved.
To exit Channel Aliasing Mode, long press
the PTT button.
CLONING MODE
Enables radio to enter cloning mode in order to
clone its profile settings into other radios (using
the Radio to Radio Cloning Cable or Multi-Unit
Charger).