Midland Radio SP-410 - Manual (Page 12)

SP-400 Series User’s Guide
Setup
Unpacking
The following items are supplied in the standard package:
5
One transceiver (SP-410, SP-420, SP-430 or SP-440)
5
One battery pack (18-B02)
5
One belt clip (81-BC1)
5
One plastic accessory dust cover
5
One rubber easy access dust cover
5
One user’s manual
If something is missing please promptly advise your supplier.
Attaching and removing the antenna
To attach the antenna:
1. Locate the antenna terminal (threaded female connector) on
transceiver’s top.
2. Hold the transceiver with one hand and the base (the
thicker part) of the antenna with the other hand.
3. Attach the included rubber antenna to the antenna terminal
by turning it clockwise until it is firmly seated. Do not
overtighten.
To remove the antenna, turn the antenna base counterclockwise.

The antenna should always be attached to the radio
when it is operated. Transmitting without the
antenna may damage the transmitter. Use only the
recommended antennas.
12
© 2005, Midland Radio Corporation