Midland Radio SP-410 - Manual (Page 14)

SP-400 Series User’s Guide
To install the belt clip onto the battery pack’s body:
1. Slide the clip into the
appropriate guides
located on the back of
the battery until it firmly
locks.
To remove the belt clip:
2. Gently lift the belt clip
release.
3. While lifting the belt clip release slide the belt clip off the
battery.
Charging the battery pack
The battery pack should be charged prior to use. To charge the
battery pack you should setup the charger and insert the radio
(or battery) as follows:
1. Connect the DC
plug on the AC
adapter to the
mating socket on
the back of the
charging cradle.
2. Plug the AC
adapter into a
grounded AC
power outlet
which supplies
the specified
input voltage for
the AC adapter.
3. Make sure the radio is switched off.
4. Insert the radio into the cradle with the front of the radio
facing toward the front of the cradle (the three metallic
14
© 2005, Midland Radio Corporation