Mabe Canada JGB918 - Manual (Page 36)

36
Care and cleaning of the range.
Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
Burner Caps and Heads
Burner caps
Lift off when cool. Wash burner caps
in hot, soapy water and rinse with clean
water. You may scour with a plastic scouring
pad to remove burned-on food particles.
Center Griddle Burner
For proper ignition, make sure the
small hole in the section that fits over the
electrode is kept open. A sewing needle
or wire twist-tie works well to unclog it.
The slits in the burner heads must be kept clean
at all times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes
will not allow the burner to operate properly.
Any spill on or around an electrode must
be carefully cleaned. Take care to not hit an
electrode with anything hard or it could
be damaged.
You should clean the burner caps and
burner heads routinely, especially after bad
spillovers, which could clog the openings
in the burner heads. Lift off when cool.
To remove burned-on food, soak the
burner heads in a solution of mild liquid
detergent and hot water for 20–30 minutes.
For more stubborn stains, use a toothbrush.
NOTE: Do not use steel wool or scouring powders
to clean the burners.
After cleaning
Before putting the burner caps and heads
back, shake out excess water and then dry
them thoroughly by setting in a warm oven
for 30 minutes.
Round Burner Bases
The round burner bases are not removable.
only the caps may be removed for cleaning.
To clean the burner bases, use soapy water
and a plastic scouring pad. Wipe clean with
a damp cloth.
Make sure that no water gets into the
burner bases. Allow them to dry fully
before using.
Replacement
Replace the burner caps. Make sure that
the caps are replaced in the correct
location. There is one oval (center) head
and cap assembly. There is one small, one
medium, one large, and one extra large
round burner cap.
Medium burner
head and cap
Front of range
Large burner
head and cap
Small burner
head and cap
Extra large burner
head and cap
Oval head and cap
assembly
Electrode
Slot
Make sure the slot in the burner head
is positioned over the electrode. Use a
sewing needle or twist-tie to unclog
the small hole in the burner head.
Burner cap is properly seated.
Burner cap is NOT properly seated.