MITSUBISHI ELECTRIC 882.00273.00 - Manual (Page 47)

Operator Displays
The Slide Gate/Auger blending system utilizes a standardized menu format. Each screen
was designed to be user-friendly and provide the operator with the necessary information to
run the blender.
Figure 33: Typical Recipe Entry Operator Screen
A typical menu is shown in the figure above. This display, which is defaulted to when the
controller is turned on, provides the operator with the following information and options:
• The ability to change Recipe Values
• Accept a newly entered Recipe
• Start or Stop the blender
• Access to the Recipe Book
• Access to the Clean-out Screen
• Access to the Inventory Screen
• Access to the Controller Setup Screen
The menu tree shows the structure for a standard Slide Gate/Auger blender.
When the unit is initially installed the Manual Control menu will be used. This screen is
primarily used for trouble shooting the blender. All outputs can be controlled manually and
all digital inputs from the proximity switches can be viewed. Pressing the “Manual Control”
key when in the “Setup” menu accesses this screen. To gain access to the “Setup” menu, a
password will be requested.
Figure 34: Typical Manual Control Operator Screen
BF1-615.3 Chapter 4: 3BOperation 47 of 101