Dmt settings – Motorola 2200 User Manual

Page 159

Advertising
background image

159

DMT Settings

DSL Commands

set dmt dsl-annex-support [ off | on ]

This controls whether other annex suppor t (just as Annex M) is enabled. Default is

off.

set dmt type [ lite | dmt | ansi | multi | adsl2 | adsl2+ | readsl2 |
adsl2anxm | adsl2+anxm ]

Selects the type of Discrete Multitone (DMT) asynchronous digital subscriber line (ADSL) protocol to
use for the WAN inter face.

The

type value also supports the following settings on certain model units: adsl2, adsl2+, readsl2,

adsl2anxm, adsl2+anxm.

NOTE:

Some

dmt type settings are now supported for many Annex B (335xN) platforms. 2200

Series and 33xxN Series models are suppor ted. Currently,

adsl2anxm and adsl2+anxm

are not suppor ted in Annex B.

set dmt autoConfig [ off | on ]

Enables suppor t for automatic VPI/VCI detection and configuration. When set to

on (the default), a pre-

defined list of VPI/VCI pairs are searched to find a valid configuration for your ADSL line. Entering a
value for the VPI or VCI setting will disable this feature.

set dmt dmt dying-gasp [ default | off | on ]

Enables or disables Gateway “dying gasp” behavior in cases of power failure. Default is

off.

set dmt wiringMode [ auto | tip_ring | A_A1 ]

(not suppor ted on all models) This command configures the wiring mode setting for your ADSL line.
Selecting

auto (the default) causes the Gateway to detect which pair of wires (inner or outer pair) are in

use on your phone line. Specifying

tip_ring forces the inner pair to be used; and A_A1 the outer pair.

set dmt metallic-termination [ auto | disabled | always_on ]

(not suppor ted on all models) This command allows you to apply a sealing current to “dr y” DSL lines so
that the wiring doesn’t corrode.

auto - The device will scan for standard telephone service (POTS). If it finds POTS, it disables metal-

lic termination. If it does not find POTS during the search period, then metallic termination is
enabled.

disabled - There is no POTS detection, and metallic termination is disabled.
always_on - The device will scan for POTS for information only. Metallic termination is always

enabled.

Advertising