Miele G858SCVI - Manual (Page 14)

Programming the water softener
Your water hardness level must be pro-
grammed into the dishwasher using the
buttons on the control panel.
The programming can be cancelled
and restarted at any time by turning
the dishwasher off using the "Off"
button, (16).
^ Open the door.
^ Turn off the dishwasher.
^ Press and hold the a and c buttons.
At the same time turn on the dish-
washer with the "On" (15) button.
^ Release all buttons.
The "Salt" and
b indicators will flash.
If this is not the case, the above steps
must be repeated.
^ Press the b button.
The
b indicator goes out and the "Salt"
indicator will flash.
If your water hardness is greater
than 12 gr/gal (220 ppm) proceed to
the next page.
1 - 12 gr/gal:
An indicator corresponding to a preset
water hardness will light (see Table 1).
Table 1:
gr/gal* ppm Button
1 - 4** 20 - 70
a
5 - 6 90 - 110
b
7 130
c
8 - 10 140 - 180
d
11 - 12 200 - 220
e
* US gallons
** Factory preset
If this value corresponds with the water
hardness in your area:
^ Turn off the dishwasher.
If you need to program a different water
hardness:
^ Press the button, which corresponds
with your water hardness (see
Table 1).
The "Salt" and
b indicators will flash.
^ Press the f button twice.
The "Salt" and
f indicators will flash.
The new water hardness is set.
^ Turn off the dishwasher.
Before using for the first time
14