MITSUBISHI ELECTRIC MITSUBISHI ELECTRIC IMMERSIVE SOUND LCD HDTV SeriesLT-40151 - Manual (Page 78)

78 Appendices
Cleaning Recommendations
Normally, light dusting with a dry, non-scratching duster
will keep your TV clean. If cleaning beyond this is
needed, please use the following guidelines:
First, turn off the TV and unplug the power cord from
the power outlet.
Top and Sides of the TV
Occasionally clean dust build-up from the air-intake •
grilles on the back and sides of the TV. Clean using
a vacuum cleaner with a brush attachment.
Gently wipe down your TV with a soft, non-abrasive
•
cloth such as cotton flannel, microfiber, or a clean
cloth diaper, lightly moistened with water. Dry with
a second dry, soft, non-abrasive cloth.
For oily dirt, add a few drops of mild liquid deter- •
gent, such as dishwashing detergent, to the water
used to moisten the cloth. Rinse with a second
cloth moistened only with water. Dry with a third
dry, soft, non-abrasive cloth.
Glossy Surfaces:
• Take special care when cleaning
the TV’s glossy surfaces.
Always shake or brush the cleaning cloth first to -
remove any dirt particles.
Wipe the glossy areas gently, without applying -
pressure.
If necessary, lightly dampen the cloth with
-
water. Use no chemical or abrasive cleaners.
LCD Screen Cleaning
IMPORTANT
DO NOT apply any type of liquid to the surface of
the TV screen.
Use only a soft, dry cloth to clean the LCD •
screen. Do not use any liquids.
Wipe the screen gently with an up and down •
motion.
Clean the entire screen evenly, not just sections of •
the screen.
Care of the Remote Control
Remote Control Tips
For longer life, use alkaline batteries. •
Do not mix old and new batteries. •
Be within 20 feet of the equipment. •
Do not press two or more keys at the same time •
unless instructed to do so.
Do not allow the unit to get wet or become heated.
•
Keep the unit out of direct sunlight. •
Avoid dropping on hard surfaces. •
Do not use harsh chemicals to clean. Use only a •
soft, lightly moistened cloth.
Resetting the Remote Control
If
TV mode is selected and the TV does not respond
properly, reset the remote control.
Press and hold
1. POWER for several seconds until the
mode indicator blinks twice and goes off.
Release the
2. POWER key.
Press keys 3. 0 0 9 3 5 and the mode indicator will
blink twice when you finish entering the code.
When entering the code, pause for a moment
between each key press to ensure it is recognized.
Low-Battery Indicator
If you press a key and the mode indicator blinks five
times, replace the remote control’s batteries.
Appendix C: TV Care
General Cleaning Precautions
DO NOT allow liquid to enter the TV through the •
ventilation slots or any crevice.
DO NOT use any strong or abrasive cleaners, as
•
these can scratch the surfaces.
DO NOT use any cleaners containing ammonia,
•
bleach, alcohol, benzene, or thinners, as these can
dull the surfaces.
DO NOT spray liquids or cleaners directly on the
•
TV’s surfaces.
DO NOT scrub or rub the TV harshly. Wipe it gently. •