Advanced base settings, 1 set the dial mode, 2 set the flash time – Motorola S803 User Manual
Page 28
28
Advanced Base Settings
3. Press
P
and
,
to select
Yes
or
No
.
4. Select
Yes
and press
P
to enter the registration
procedure as below:
1. Place the unregistered cordless handset on the
charger.
2. Press and hold
v
for 4 seconds on base.
3. Release
v
once IN USE LED is flashing.
4. A confirmation tone is generated if registration is
successful.
Handset X
is displayed where
X
denotes the
number of handsets and the phone goes back to idle.
7. Advanced Base Settings
7.1
Set the Dial Mode
The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press
P
and
,
to select
Setup Base
.
2. Press
P
to select
Dial Mode
.
3. Press
P
and
,
to select
Tone
or
Pulse
.
4. Press
P
to save.
NOTE
If pulse mode is selected, press
*
to switch from pulse to
tone dialing temporarily when dialing out. After the call is
ended, the dial mode will change back to pulse.
7.2
Set the Flash Time
The default flash time is 600ms. It is unlikely that you should
need to change this setting unless advised to do so.
1. Press
P
and
,
to select
Setup Base
.
2. Press
P
and
,
to select
Flash Time
.