Mustek PP7000-II - Manual (Page 29)

D. SOFTWARE COMMANDS
The Aura thermal printer supports all commands applicable
to Epson printer TM-T88II. The only difference is the
smoothening command in enlarged text fonts. Please visit our
web site http://www.posiflex.com.tw, http://www.posiflextw.com,
http://www.posiflexuk.com or http://www.posiflexusa.com for
detail description of the supported commands if required.
1. Enhancement commands
Following commands are included in the printer firmware
version since ver. 3.2:
ESC ‘o’: Beep command
GS ‘o’ m: Beep definition (0 < m
16, default 3 seconds)
ESC ‘p’ m n1 n2: Cash drawer kick or kitchen bell drive
command
GS ‘p’ m n: Beep when cash drawer remain open (0 < m <
256, n = ‘0’ or ‘1’)
Explanations as below:
ESC ‘o’: Beep command
Hexadecimal codes are: 1B 6F
Printer beeps when this command is received per condition
set by beep definition.
GS ‘o’ m: Beep definition (0 < m
16, default 3 seconds)
Hexadecimal codes are: 1D 6F m
This command defines length of beep as m seconds when
beep command is received. When m = 0, default applies.
5 - 5