Miele G 1472 - Manual (Page 34)

Buzzer
A signal sounds at the end of a
program and when a fault occurs.
The buzzer at the end of a program
sounds five times in quick succession
for up to one hour.
The buzzer for a fault sounds in
intervals up to two minutes.
The buzzer is activated by default. It
can be turned off, so it does not sound
at the end of a program. The buzzer for
a fault cannot be turned off.
^ Open the door.
^ Turn the dishwasher off with "o".
^ Press the "Program" button and at the
same time turn the dishwasher on
with "
g".
^ Hold the program button until the
lower right program indicator comes
on.
If it does not come on, start over.
^ Press the"Options" button four times.
The "Tab" indicator flashes four times in
intervals.
The time display shows if the program
end buzzer is turned on or off.
– "
p 1": Buzzer is turned on
– "
p 0": Buzzer is turned off
^ Press the "Program" button to change
the setting.
The setting is saved.
^ Turn the dishwasher off with "o".
Default settings
All settings can be reset to the factory
default.
^ Open the door.
^ Turn the dishwasher off "o".
^ Press and hold the "Program" button
and at the same time turn the
dishwasher on "
g". Hold the "Program"
button until the lower right program
indicator comes on.
If it does not come on, start over.
^ Press the "Options" button 12 times.
The "Tab" indicator flashes once long
and twice short in intervals.
The time display shows if a setting was
changed.
– "
p 1": All settings are factory default.
– "
p 0": At least one setting was
changed.
^ To reset the dishwasher to the factory
default, press the "Program" button.
The setting is saved.
^ Turn the dishwasher off "o".
Additional options
34