Installation of i/o cards – MACKIE Digital 8Bus D8B v5.1 User Manual

Page 107

Advertising
background image

D8B Manual • Chapter 4 • page 101

Installation of I/O Cards

IMPORTANT:

Shut off power to the

Digital 8•Bus’ Remote CPU before
installing or removing cards.

1. Using a #2 Philips screwdriver, unscrew the blank

cover plate corresponding to the I/O card slot you
want to fill.

2. Holding the I/O card so that the components on

the green circuit board face to the left (see
diagram), line up the card so the top and bottom
edges fit into the white guide slots. Do not touch
any of the circuit board components or solder joints.

3. Be sure to push the card in all the way—until the

front of the I/O card is flush with the back panel of
the D8B. This may require a good, solid push, so
don’t be shy.

4. Tighten the spring-loaded screws on the

I/O card securely using a slotted screwdriver. DO
NOT OVERTIGHTEN THE SCREWS, or you run
the risk of stripping the threads in the D8B.

Tighten Screws on Tape I/O Card

Installing a Tape I/O Card

Remove Cover Plate for Tape I/O Card

Advertising