Miele Platinum G 892 SC - Manual (Page 15)

Programming the water softener
Your water hardness level must be
programmed into the dishwasher using
the buttons on the control panel.
^ Make sure the dishwasher is turned
off.
^ Press and hold the "Start/Stop" button
(17) and at the same time turn on the
dishwasher with the "On/Off" button
(13). Release the "Start/Stop" button
within two seconds.
The "Rinse" (16) indicator and a
program indicator will light and the
"Salt" (15) indicator will flash.
If this is not the case, the above steps
must be repeated.
If your water hardness is greater
than 22 gr/gal (400 p.m.) proceed to
the next page.
1 - 22 gr/gal:
^ Use the program selection buttons
(19) to select the program which
corresponds to the water hardness in
your area.
Table 1
gr/gal* ppm Program indicator
1 - 4** 20 - 70 Pots & Pans
5 - 7 90 - 130 Sani Wash
8 - 10 140 - 180 Normal Plus
11 - 13 200 - 230 Normal
14 - 16 250 - 290 Economy
17 - 22 310 - 400 Rinse & Hold
* US gallons
** Factory preset
To store the programmed water
hardness:
^ Press the "Start/Stop" (17) button
twice.
^ Turn off the dishwasher.
Before using for the first time
15