Mocomtech CDM-570 - Manual (Page 153)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Front Panel Operation MN/CDM570L.IOM
6–29
Edit the address of the distant-end modem to which this unit will pass
messages. This is accomplished by selecting the digit to be edited, using
the
◄ ► arrow keys. The value of the digit is changed using the ▲ ▼
arrow keys. The user should then press ENTER.
There is a restriction on values which can be entered here; they may only
be entered in increments of 10. This is automatically taken care of; the
user may not edit the last digit of the address. This has been implemented
so that a single Master may pass messages for up to 10 devices at the
distant end. The valid range of addresses is from 10 to 9990.
But if Slave is selected, then the following sub-menu is displayed:
Edit the address of this Slave unit. This is accomplished by selecting the
digit to be edited, using the
◄ ► arrow keys. The value of the digit is
then changed using the ▲ ▼ arrow keys. The user should then press
ENTER. The valid range of addresses is from 1 to 9999, although ‘base
10' values will be automatically skipped. The Slave EDMAC address
will always end in ‘1’.
Remember that this is a unit which is intended to be located at the
distant-end of a link, and will therefore be under the control of a Master
at the other end. This is the equivalent of putting the unit into Remote
Control mode; no local control is possible.
Address of this Slave
Unit: 0241 (
◄ ►,▲ ▼,ENT)
Distant-end Base Address
0240 (
◄ ►,▲ ▼,ENTER)