Mocomtech CDM-570 - Manual (Page 24)

Page 14 of 54 MN/CDM570L.AA4
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
SNMP Trap
Destination IP
Address-2 STB= 15 bytes,
Numerical Command or Query.
Used to set the IP address of the SNMP Trap destination IP
Address where traps will be sent, in the format:
xxx.xxx.xxx.xxx is the IP addresss
Example: 010.006.030.001
Returns >0001/STB=0.0.0.0 When not configured.
STB =
STB!
STB? STB = xx.xxx.xxx.xxx
(see description of
arguments)
SNMP Trap
Version STV= 1 byte, value
of 0 or 1 Command or Query.
1=Snmpv1
2=Snmpv2
Specifies the version of snmp traps that should be sent.
STV =
STV!
STV? STV = x
(see description of
arguments)
SNMP Trap
Enable
Authentication
Traps SAT= 1 byte, value
of 1 or 2 Command or Query
where,
2=Disabled
1= Enabled
Enables or disables sending SNMP authentication traps.
SAT =
SAT!
SAT? SAT =x
(see description of
arguments)
SNMP
System
Contact SSC= 128 bytes,
characters, Command or Query.
SNMP System Contact string
Example: <1/SSC=Joe Net Admin. If not configured it returns
empty string.
<1/SSC= SSC =
SSC!
STC? STC =x [1..128]
(see description of
arguments)
SNMP
System Name SSN= 128 bytes,
characters, Command or Query.
SNMP System Name string
Example: <1/SSN=Remote1. If not configured it returns empty
string.
<1/SSC= SSN =
SSN!
SSN? SSN =x [1..128]
(see description of
arguments)
SNMP
System
Location SSL= 128 bytes,
characters, Command or Query.
SNMP System Location string
Example: <1/SSL=Upstairs back right. If not configured it returns
empty string.
<1/SSL= SSL =
SSL!
SSL? SSL =x [1..128]
(see description of
arguments)