Mocomtech CDM-570 - Manual (Page 249)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Serial Remote Control MN/CDM570L.IOM
13–15
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
External
Reference
Frequency ERF= 1 byte, value
of 0 thru 5 Command or Query.
External Reference Frequency, where:
0=Internal
1=External 1 MHz
2=External 2 MHz
3=External 5 MHz
4=External 10 MHz
5=External 20 MHz
Example: ERF=0 (External reference not used - uses internal) ERF=
ERF?
ERF *
ERF # ERF? ERF =x
(see description of
arguments)
EDMAC
Framing Mode EFM= 1 byte, value
of 0, 1 or 2 Command or Query.
EDMAC mode, where:
0 = EDMAC OFF (Framing is on, AUPC active)
1 = EDMAC MASTER
2 = EDMAC SLAVE (Query Only)
Example: EFM=1 (EDMAC Enabled as Master) EFM=
EFM?
EFM*
EFM# EFM? EFM=x
(see description of
arguments)
EDMAC Slave
Address Range ESA= 4 bytes Command or Query.
EDMAC Slave Address Range - sets the range of addresses of
distant-end units (modems or transceivers) for which this unit, as
the Master, will forward messages. Only values which are integer
multiples of ten are permitted. (0010, 0020, 0030, 0040, etc.).
Example: ESA=0090
This command is only valid for an EDMAC master.
When used as a Query, it may be sent to an EDMAC slave, which
will respond with the appropriate address. ESA=
ESA?
ESA*
ESA#
ESA? ESA=xxxx
(see description of
arguments)
IP Address IPA= 18 bytes,
numerical Command or Query.
Used to set the IP address and network prefix for the
10/100 BaseT Ethernet management port, in the format:
xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Example: 010.006.030.001.24 IPA=
IPA?
IPA*
IPA#
IPA? IPA= xx.xxx.xxx.xxx.yy
(see description of
arguments)