Mocomtech CDM-570 - Manual (Page 254)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Serial Remote Control MN/CDM570L.IOM
13–20
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Number of
Unread stored
Events N/A 3 bytes Query only.
Unit returns the Number of stored Events, which remain Unread, in
the form xxx.
Note: This means unread over the remote control.
Example: NUE=126 N/A NUE? NUE=xxx
(see description of
arguments)
Retrieve next 5
unread Stored
Events N/A 75 bytes Query only.
Unit returns the oldest 5 Stored Events which have not yet been
read over the remote control. Reply format: {CR}Sub-
body{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-body,
where Sub-body= ABCddmmyyhhmmss,
A being the fault/clear indicator.
F=Fault
C=Clear
I=Info
B being the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=ODU
5= Power on/off, or log cleared
C is Fault Code numbers, as in FLT? or Info Code, which is:
0=Power Off
1=Power On
2=Log Cleared
3=Global Config Change
4=Redundancy Config Change
If there are less than 5 events to be retrieved, the remaining
positions are padded with zeros.
If there are no new events, the response is RNE*.
N/A RNE? RNE={CR}ABCddmmy
yhhmmss{CR}ABCddm
myyhhmmss{CR}ABCd
dmmyyhhmmss{CR}AB
Cddmmyyhhmmss
{CR}ABCddmmyyhhm
mss
(see description for
details of arguments)
Clear All
Stored Events CAE= None Command only.
Forces the software to clear the software events log.
Example: CAE=
Note: This command takes no arguments.
CAE=
CAE?
CAE*
CAE# N/A N/A