Mocomtech CDM-570 - Manual (Page 29)

Page 15 of 54 MN/CDM570L.AA4 25
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Qos Rule QSR= QSR[0..32]=
Index-0 is the
default rule Command or Query.
QSR=tt|p|sss.sss.sss.sss/ss|ddd.ddd.ddd.ddd/dd|AAAAA|BBBBB|C
CCCC|DDDDD|mmmmm|MMMMM|w|f
Where t = Protocol Type:
01 - UDP 02 - TCP 03-ICMP
04-RTP 05-VOCE 06-VDEO
07-RTPS
08-FTP 09-HTTP 10-TELN 11-SMTP
12-SNMP 13-SAP 14-ORCL
15-CTRX 16-SQL 17-IP 18 for N-IP
19-ALL [Valid only for default rule]
Where p =
PRI=1..8 (only applies in max/priority mode). In Min/Max mode
priority for all rules is fixed at 8. User should not be alled to change
priority in Min/Max mode. Priority-9 is being used for default rule,
and obtained from PARAM file. Pri-9 cannot be used for
configuring other rules.
Where s = Source IP
SIP=xxx.xxx.xxx.xxx/yy [yy – subnet mask]. All ‘*’ signifies all IP
address range[***.***.***.***/**].
Where d = Destination IP
DIP=xxx.xxx.xxx.xxx/yy [yy – subnet mask]. All ‘*’ signifies all
IP address range, like [***.***.***.***/**]
All ‘*’ signifies all port range of
00000 – 65535 for TCP/UDP. All port
numbers should in fixed length of 5-chars
Where A = TCP/UDP Source Port range
SPS=aaaaa [Source Port range Start]
Where B = [Source Port range Finish]
SPF=bbbbb
Where C = [Dest Port range Start]
DPS=ccccc
Where D = [Dest Port range Finish]
DPF=ddddd
Where m =
MINBW = mmmmm (meaningful in min.max mode). This is 0 in
Max Priority
mode. The number should be mentioned with preceding zeros, to
make it a fixed length of 5-chars.
Where M =
MXB=MMMMM (meaningful in max/pri and min./max modes
only). The number should be mentioned with preceding zeros, to
make it a fixed length of 5-chars.
W = WRED = 0-No 1-Yes
F = FILTER = 0-No 1-Yes QSR =
QSR!
QSR[0..32]?
Index-0 is the
default rule QSR[0..32] =
See description.
Index-0 is the default
rule