Mocomtech CDM-570 - Manual (Page 36)

Page 14 of 54 MN/CDM570L.AA4
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for
Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Boot From
Software
Image BLI= 1 byte, value
of 0,1,2 Command or Query.
Image which will be used the next time the system is booted, where:
0=Latest
1=Bulk Image # 1
2=Bulk Image # 2
Example: BLI=1 (which is Image #1 active) BLI =
BLI!
BLI? BLI =x
(see description of
arguments)
Base Modem
Boot From BBI= 1 byte value
0,1,2 Command or Query.
The binary image, which will be used by the base modem, to boot
with.
Where
0 – Latest
1 – Image in Slot# 1
2 – Image in Slot#2.
Example: <1/BBI=0
BBI=
BBI! BBI? BBI=x
(see description of
arguments)
Param file
image to use PFI= 1 byte, value
of 1 or 3 Command or Query.
Image which will be updated the next time firmware is uploaded to
the system:
1=Param1
3=Factory Default
To restore the Factory Defaults, set PFI=3 and issue RST to reset the
box. This would bring up the box with factory default configuration.
Example: PFI =1 (using param image on flash)
PFI =
PFI!
PFI? PFI =x
(see description of
arguments)
Save System
Configuration
Parameters SCS= 1 byte value
1 – Save
config Command only
Setting SCS to ‘1’, will save all the active system configuration on to
the Flash. SCS=
SCS! N/A SCS=x
(see description of
arguments)