Mocomtech CDM-570 - Manual (Page 95)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Preface MN/CDM570L.IOM
xvii
Reporting Comments or Suggestions Concerning this Manual
Comments and suggestions regarding the content and design of this manual will be
appreciated. To submit comments, please contact the Comtech EF Data Technical
Publications Department: [email protected].
Electrical Safety
The CDM-570/570L Modem has been shown to comply with the following safety
standard:
• EN 60950: Safety of Information Technology Equipment, including electrical business
machines
The equipment is rated for operation over the range 100 - 240 volts AC. It has a
maximum power consumption of 250 Watts (when equipped with a 150W BUC power
supply), and draws a maximum of 2.5 Amps.
IMPORTANT
The user should observe the following instructions:
Fuses
The CDM-570/570L is fitted with two fuses - one each for line and neutral connections.
These are contained within the body of the IEC power inlet connector, behind a small
plastic flap.
• For 230 volt AC operation, use T2.5A, 20mm fuses.
• For 115 volt AC operation, use T5.0A fuses, slow blow, P/N 5ASB-IEC.
The DC CDM-570/570L is fitted with two fuses – one each for positive and negative
connections. These are contained within the body of the power inlet , behind a small
plastic flap.
• For 38 to 60 VDC operation, use T2.0A, 20mm fuses if the modem has no BUC
power supply.
• For 38 to 60 VDC operation, use T8.0A, 20 mm fuses if the modem is fitted with
internal BUC power supply.
FOR CONTINUED OPERATOR SAFETY, ALWAYS REPLACE THE FUSES
WITH THE CORRECT TYPE AND RATING.