Mocomtech CDM-570 - Manual (Page 294)

CDM-570/570L Satellite Modem with Optional IP Module Revision 4
Typical IP Module Operation Setups MN/CDM570L.IOM
16.3 IP Module Working Modes
Two Working Modes of the IP Module are available: easyConnect
™ and Router Mode.
There are also three HDLC Addressing Modes: Point-to-Point, Small Network, and Large
Network. Separate HDLC Modes allows the user to minimize the HDLC overhead
transmitted over the satellite based upon the size of their network. In Router/Point-to-
Point Mode, no HDLC address is transmitted; Router/Small Network transmits 1 byte
and Router/Large Network transmits 2 bytes as part of HDLC header for each packet.
Non-IP traffic is not supported in Router Mode.
This section describes the functionality of these modes in order to optimize the
Comtech EF Data IP modems in the network, based upon Network Topology and
Ethernet Traffic requirements.
IMPORTANT
The Working Mode and HDLC Address Mode of the Comtech EF Data IP modems
must be identical to pass traffic between modems.
Changing the Working Mode or HDLC address Mode of the IP modem requires the IP
Module to be rebooted. Before the user can select a different mode, the IP Module
will notify the user that changing the mode will require a reboot.
Working Mode
HDLC Address Mode
Network Topology Ethernet Traffic
easyConnect
™ Mode
Point-to-Point
Point-to-Point only
Both sites on same LAN subnet
IP v4 and/or non-IP
Router Mode
Point-to-Point
Point-to-Point only
Both sites on different LAN subnet
IP v4 only
Router Mode
Small Network
Point-to-Point or Point-to-Multipoint
(up to 254 sites)
All sites on different LAN subnet
IP v4 only
Router Mode
Large Network
Point-to-Point or Point-to-Multipoint
(up to 32766 sites)
All sites on different LAN subnet
IP v4 only
16–2