Philips Magnavox MPD8710 User Manual

Quick start guide, Guide de démarrage rapide, 3 open here

Advertising
background image

1 Slide the POWER switch to the OFF position

(charging of the DVD player only possible in the
power-off mode).

2 Connect the supplied power adaptor to the player

and to AC outlet to start charging.

➜ The red CHR indicator turns on. It takes

about 4 hours to fully charge the battery.

➜ When the battery is fully charged, the indicator

turns off.

IR/POWER/CHR

Quick start guide

Magnavox Portable DVD Player MPD8710

Charge

1

Notes:
– It is impossible to charge the battery when the environ-

ment temperature drops below 0°C or exceed 35°C.

– When the environment temperature is above 35°C, the

indicator twinkles.

2

Prepare your remote control

1 Open the battery compartment.
2 Insert 1 x lithium 3V battery, type CR2025, with the

correct polarity (+/-) as indicated).

3 Close the battery compartment.

3

Enjoy (Disc operation)

1 Open the lid of the player.
2 Slide the POWER switch to ON to turn on the

DVD player.
➜ The green POWER indicator turns on.

3 Press OPEN to open the disc door.
4 Remove the protective card (if any) and load a disc

with the label side facing up.

5 Close the disc door. Playback will start automatical-

ly. If not, press

2;.

6 To stop playback, press

9. twice.

4

Enjoy (AV OUT)

Connecting additional equipment (TV for
example)

1 Connect the AV OUT socket on the set to the

video and audio sockets on a TV as shown.

2 Switch on the TV and set to the correct video-in

channel.

➜ You can consult the owner's manual of your TV.

(If your TV does not have Audio and Video
inputs, you will need to purchase a RF modula-
tor. Please consult your dealer.)

Guide de
démarrage rapide

1 Réglez l'interrupteur POWER sur OFF (le lecteur

de DVD peut être chargé en mode hors tension
uniquement).

2 Pour démarrer la charge, utilisez le cordon de

l'adaptateur secteur fourni pour brancher le lecteur
sur une prise secteur.

➜ Le voyant de charge rouge est allumé. Une

charge complète de la batterie prend environ 4
heures.

➜ Lorsque la batterie est entièrement chargée, le

voyant de charge rouge s’éteint.

Charge de la batterie

1

Remarque:
– Lors de la charge de la batterie, la température doit

être comprise entre 0 et 35°C.

– WesternLorsque la température dépasse 35°C, le voy-

ant clignote.

2

Préparation de la télécommande

1 Ouvrez le compartiment des piles.

2 Insérez 1 pile CR2025 en respectant la polarité

(+/-) indiquée.

3 Refermez le compartiment des piles.

TV

AUDIO IN

White
Red
Yellow

VIDEO IN

IR/POWER/CHR

3 OPEN HERE

Advertising