Minicom Advanced Systems Minicom Smart 216 - Manual (Page 13)

USER GUIDE
12
2. Switch on the Smart 216 / 232 IP.
10. Setting the IP address
By default, Smart 216 / 232 IP boots with an automatically assigned IP address
from a DHCP (Dynamic Host Configuration Protocol) server on the network. The
DHCP server provides a valid IP address, gateway address and subnet mask.
You can identify the IP address from the OSD at the local position. Also where
there is no DHCP server, set the IP address locally via the OSD as follows:
1. From the local keyboard, press Shift twice. The OSD Main window appears.
See Figure 11.
Figure 11 OSD Main window
2. Press F2. The Settings window appears see Figure 12.
Figure 12 Settings window
In the Settings window navigate downwards using the Tab key. At the bottom of
the window, press tab to go to the top of the window. Change settings by typing in
the selected area or by pressing the spacebar – whichever is relevant.