ICP DAS USA DB25 - Manual (Page 62)

Application Notes – PLCs and Devices
56
T
OSHIBA
EX
AND
M S
ERIES
PLC
S
Registers Accessed
The DN-3000 will only access registers in the Data Register of PLC memory (D0 to D9999). When
entering register numbers, only the offset into this area (0-9999) should be entered. For example, to
access register number D0, the value 0 should be entered. To access register number D9999, the value
9999 should be entered.
Protocols Supported
The DN-3000 will only communicate with Toshiba EX and M Series PLCs using the Binary Computer
Link protocol.
T
OSHIBA
T S
ERIES
PLC
S
Registers Accessed
The DN-3000 will only access registers in the Data Register of PLC memory (D0 to D9999). When
entering register numbers, only the offset into this area (0-9999) should be entered. For example, to
access register number D0, the value 0 should be entered. To access register number D9999, the value
9999 should be entered.
Protocols Supported
The DN-3000 will only communicate with Toshiba T Series PLCs using the ASCII Computer Link
protocol.
W
ESTINGHOUSE
PLC
S
Registers Accessed
The DN-3000 will only access registers in the Holding Register of PLC memory (HR1 to HR9999).
When entering register numbers, only the offset into this area (1-9999) should be entered. For example,
to access register number HR1, the value 1 should be entered. To access register number HR9999, the
value 9999 should be entered.