Insignia NS-HTIB51A - Manual (Page 16)

12
Insignia NS-HTIB51A 5.1 Channel Home Theater System
www.insigniaproducts.com
Wall mounting your speakers
The speakers can easily be wall mounted by using
the keyhole slots.
To mount the front or surround speakers vertically,
use the keyhole slot shown to hang each speaker
on a screw that is securely screwed into the wall.
To mount the center speaker horizontally, use the
two keyhole slots shown to hang each speaker on
two screws that are securely screwed into the wall.
Installing batteries in the remote control
To install the batteries:
1 Remove the cover.
2 Insert two AA batteries into the compartment
matching the polarity indicated.
3 Replace the cover.
Using the remote control
Use the remote control by pointing it towards the
receiver’s remote sensor window. Objects between
the remote control and sensor window may
prevent proper operation.
Use the remote control within about 16 feet
(5 meters) of the receiver and within 30 degrees of
perpendicular to the front of the receiver.
Using the Audyssey 2EQ® room correction
and speaker setup
With the supplied calibration microphone,
Audyssey 2EQ automatically determines the
number of speakers connected, their size (for
purposes of bass management), optimum
crossover frequencies to the subwoofer (if present),
and distances from the primary listening position.
Audyssey 2EQ then removes the distortion caused
by room acoustics by capturing room acoustical
problems over the listening area in both the
frequency and time domain. The result is clear,
well-balanced sound for everyone.
Enabling Audyssey 2EQ lets you also use Audyssey
Dynamic EQ®, which maintains the proper
octave-to-octave balance at any volume level.
Cautions
• A mounting screw’s ability to support a speaker
depends on how well it’s anchored to the wall. If
you have hollow walls, screw each mounting
screw into a stud. If there are no studs, or the
walls are solid, use suitable wall anchors.
• Use screws with a head diameter of 5/16"
(9 mm) or less and a shank diameter of 1/8"
(4 mm) or less. With hollow walls, use a
cable/pipe detector to check for any power
cables or water pipes before making any holes.
• Leave a gap of between 3/16" (5 mm) and 7/16"
(10 mm) between the wall and the base of the
screw head. (We recommend that you consult a
home installation professional.)
Cautions
• If the remote control doesn’t work reliably, try
replacing the batteries.
• Don’t mix new and old batteries or different
types of batteries.
• If you intend not to use the remote control for a
long time, remove the batteries to prevent
damage from leakage or corrosion.
• Remove expired batteries as soon as possible to
prevent damage from leakage or corrosion.
Keyhole slot for wall
mounting
Keyhole slot for wall
mounting
Front speakers
Surround speakers
8-11/16” (240 mm)
Center speaker
Keyhole slot for wall mounting
Cautions
• Do not expose the remote control to shock. In
addition, do not expose the remote control to
liquids, and do not place in an area with high
humidity.
• Do not place the remote control under direct
sunlight. The heat may cause deformation of
the remote control.
• The remote control may not work properly if the
remote sensor window of the receiver is under
direct sunlight or strong lighting. In such a case,
change the angle of the lighting or receiver, or
operate the remote control closer to the remote
sensor window.
Batteries (AA/R6)
Approx. 16 ft. (5 m)
Receiver
Remote control sensor
NS-HTIB51A_10-0114_MAN_.book Page 12 Tuesday, April 13, 2010 10:19 AM