Intel 80C188XL - Manual (Page 99)

BUS INTERFACE UNIT
3-18
Figure 3-17. Normally Not-Ready System Timing
A valid not-ready input can be generated as late as phase 1 of T3 to insert wait states in a normally
ready system. A normally not-ready system must run wait states if the not-ready condition cannot
be met in time. Figure 3-18 illustrates the minimum and maximum timing necessary to insert wait
states in a normally ready system. Figure 3-18 also shows how to terminate a bus cycle with wait
states in a normally ready system.
The BIU can execute an indefinite number of wait states. However, bus cycles with large numbers
of wait states limit the performance of the CPU and the integrated peripherals. CPU performance
suffers because the instruction prefetch queue cannot be kept full. Integrated peripheral perfor-
mance suffers because the maximum bus bandwidth decreases.
3.4.4 Idle States
Under most operating conditions, the BIU executes consecutive (back-to-back) bus cycles. How-
ever, several conditions cause the BIU to become idle. An idle condition occurs between bus cy-
cles (see Figure 3-8 on page 3-9) and may last an indefinite period of time, depending on the
instruction sequence.
ARDY
CLKOUT
T2
or T3
or TW
T4
In a Normally-Not-Ready system, wait states are inserted until (1 or 2) and 3 are met.
1. TARYCH : ARDY active to clock high (assumes ARDY remains active until 3).
2. TSRYCL : SRDY active to clock low.
3. TCLARX, TCLSRY : ARDY and SRDY hold from clock low.
1
2
SRDY
3
!
Failure to meet SRDY setup and hold can cause a device failure
(i.e., the bus hangs or operates inappropriately).
T3
or TW
A1511-0A