Insignia NS-BRDVD4 - Manual (Page 37)

37
Insignia NS-BRDVD4/NS-BRDVD4-CA Blu-Ray Disc Player
www.insigniaproducts.com
cable), a compatible audio signal is automatically sent over the
HDMI and optical or coaxial connections. With this setting,
Blu-ray audio is limited to the soundtrack for the main movie
(no PIP audio).
• Bitstream Legacy—Sends a DTS or Dolby Digital bitstream
from the disc over the HDMI and optical or coaxial connections.
Blu-ray audio is limited to the soundtrack for the main movie
(no PIP audio).
• Bitstream mixed—Sends a mixed (PIP audio and movie audio)
DTS audio stream over the HDMI and coaxial or optical
connections. This mode is primarily intended for use when you
want to hear both PIP audio and the movie audio.
5 Press to go to the previous menu.
Turning dynamic range control on or off
Dynamic range control is only active when a Dolby Digital signal is
detected.
When Dynamic Range Control is set to Off, movie soundtracks are
played with the standard dynamic range.
When movie soundtracks are played at low volume or from smaller
speakers, you can set Dynamic Range Control to On. Your player applies
appropriate compression to make low-level content more intelligible and
prevent dramatic passages from getting too loud.
To turn dynamic range control on or off:
1 Press or to select Settings, then press ENTER. The Settings menu
opens.
2 Press or to select Audio, then press ENTER. The Audio menu
opens.
3 Press or to select Dynamic Range Control, then press ENTER.
4 Press or to select On, Off, or Auto, then press ENTER.
5 Press to go to the previous menu.
NS-BRDVD4-BRDVD4-CA_10-0864_MAN_V6.fm Page 37 Monday, October 24, 2011 5:16 PM