Installing a drive – IBM Partner Pavilion 6350 User Manual
Page 47
Notes:
1.
Drives that are greater than 41.3 mm (1.6 in.) high cannot be installed.
2.
Install removable media (tape or CD) drives in the accessible bay: bay 1 or 2.
Installing a drive
To install an internal drive, follow these steps.
1.
Remove the cover. See “Removing the cover” on page 29.
2.
If your computer has a CD drive or DVD drive, you might need to remove the
signal and power cables from the drive.
3.
If the drive you are installing is a removable-media drive, remove the bay
panel from the front bezel.
4.
Remove the metal shield from the drive bay by inserting a flat–blade
screwdriver into one of the slots and gently prying it loose.
5.
Pivot the drive bay latch handle toward the front of the computer and then
pivot the drive bay cage upward, as shown, until it is latched in the up right
position.
6.
Make sure the drive that you are installing is set correctly as either a master or
a slave device.
v If it is a hard disk drive, set as a slave device.
Chapter 4. Installing internal options — desktop model
35