IBM Partner Pavilion T400F User Manual
Setup, operator, and service guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Safety and Environmental Notices
- Preface
- Chapter 1. Introduction
- Chapter 2. Specifications
- Chapter 3. Installing the Tape Drive
- Rear View of the SCSI Drive
- Rear View of the Fibre Channel Drive
- Step 1. Unpack the Drive
- Step 2. Remove Power from the Enclosure
- Step 3. Set the SCSI ID or Arbitrated Loop Physical Address
- Step 4. Change the Link Services of the Drive (optional)
- Step 5. Mount the Tape Drive into the Enclosure
- Step 6. Connect and Test Power to the Tape Drive
- Step 7. Connect the Internal SCSI or Fibre Channel Cable
- Step 8. Connect the Internal LDI Cable (optional)
- Step 9. Run Drive Diagnostics
- Step 10. Install the Device Drivers
- Step 11. Connect the External SCSI or Fibre Channel Interface to the Server
- Step 12. Connect the External LDI Interface to the Server (optional)
- Step 13. Configure the Tape Drive to the Server, Switch, or Hub
- Chapter 4. Operating the Tape Drive
- Chapter 5. Using the Media
- Chapter 6. Resolving Problems
- Chapter 7. Servicing the Tape Drive
- Appendix A. Tools and Supplies
- Appendix B. TapeAlert Flags
- Notices
- Trademarks
- Electronic Emission Notices
- Special Considerations for Electromagnetic Compatibility
- IBM TotalStorage LTO Ultrium 2 Tape Drive Models T400 and T400F
- Federal Communications Commission (FCC) Class B Statement
- Industry Canada Class B Emission Compliance Statement
- Avis de conformité à la réglementation d'Industrie Canada
- European Union (EU) Electromagnetic Compatibility Directive
- Germany Electromagnetic Compatibility Directive
- Japan VCCI Class B ITE Electronic Emission Statement
- Getting Help
- Warranty
- Glossary
- Index