Set print station, Select user-defined or resident character sets – IBM SUREMARK TI8 User Manual
Page 156
(676 dots) / (10 = dots per character) = 67 characters per line
v
for 120 DPI
[(motor steps - 75) * 2.5] - 10 = dots per line
v
or for a 6-inch document
(540 dots) / (10 = dots per character) = 54 characters per line
or
Attention:
It is recommended that you set the document length a few steps
shorter than the actual document. If you set the document length too long the
printer will feed the document out of the printer roller and an error will be generated.
Set print station
EIA-232 Syntax:
ESC c 0 n or X'1B;6330;n'
where:
n
Specifies the print station.
Bit # ↓ Station
(LSB) 0 Reserved
1 Customer Receipt Station
2 Document Station - Portrait Mode
3 Document Station - Landscape Mode
4 Reserved
5 Reserved
6 Reserved
( MSB) 7 Reserved
Default:
n = 02
Remarks:
See “Document handling” on page 181.
Only one station can be set at a time. If you select more than one station,
the command is ignored.
Select user-defined or resident character sets
EIA-232 Syntax:
ESC % n or X'1B;25;n'
where:
n=00
Select resident character sets
n=01
Select user-defined character sets
Default:
n = 00
Remarks:
See “Character fonts” on page 98 and “Download user-defined characters”
on page 118.
Updated April 2, 2009
134
SureMark Printers User’s Guide