Ives VR914M - Manual

829560_00(2) Copyright © 2003 Ingersoll-Rand. All rights reserved.
FOR USE WITH MORTISE DEVICES
VR910M/VR914M VANDAL RESISTANT TRIM
INSTALLATION INSTRUCTIONS
INSTALL MORTISE LOCK. SEE MORTISE LOCK
INSTRUCTIONS.
INSTALL EXIT DEVICE AND TRIM.
3
4
RHR
SHOWN
LHR
OPPOSITE
VR910M/VR914M
TRIM
SCREWS (4):
10-24 X 1”
PPHMS SCREWS
(1-3/4” DOORS)
10-24 X 1-1/2”
PPHMS SCREWS
(2-1/4” DOORS)
INSTALL CYLINDER, IF USING. 5
KEYHOLE
POSITION
WHEN INSTALLED
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR PROPER FIT
SET SCREW: REMOVE FROM CYLINDER
SIDE UNTIL CYLINDER IS SCREWED INTO
PLACE, THEN REINSTALL SCREW
CYLINDER COLLAR
3-1/2”
7”
3-1/2”
1-3/8”
13/32” DIAMETER HOLES,
4 PLACES (TRIM SIDE)
1/4” DIAMETER HOLES,
4 PLACES (OPPOSITE SIDE)
1-5/8” DIAMETER
HOLE (TRIM SIDE
OF DOOR) FOR
CYLINDERS ONLY
DEVICE & TRIM
HORIZONTAL L
C
RHR SHOWN
LHR OPPOSITE OUTSIDE FACE
OF LOCK STILE
11/16”
PREPARE PUSH SIDE OF DOOR FOR EXIT
DEVICE. SEE EXIT DEVICE INSTRUCTIONS
FOR PREPARATION.
PREPARE PULL SIDE OF DOOR FOR TRIM.
A TRANSFER VERTICAL AND HORIZONTAL
DEVICE CENTER LINES FROM PUSH SIDE
OF DOOR TO PULL SIDE.
B LOCATE AND PREPARE ALL HOLES AS
INDICATED BELOW.
1
2
DEVICE & TRIM
VERTICAL
LC
2-1/4”