IBM 6274 - Manual (Page 54)

40
User Guide
Installing memory
You can add memory to your computer to increase system performance. Your
computer has two DIMM connectors 1 for installing memory. The maximum
To install a DIMM, do the following:
1. Remove the rear computer cover. See “Removing the rear cover” on page 37.
2. Remove the hard disk drive. See “Removing the hard disk drive” on page 39.
3. Locate the DIMM sockets on the system board. See “System board” on page
35.
4. Open the module retaining clips on one of the DIMM sockets.
Note: If you are replacing an existing DIMM, remove the existing DIMM.
amount of SDRAM memory is 2 GB.