JVC GR-D640E - Manual (Page 17)

EN
17 GETTING STARTED
MasterPage: Start_Right
GETTING
ST
AR
TED
1
Adjust the velcro strip.
2
Pass your right hand
through the loop and
grasp the grip.
3
Adjust your thumb
and fingers through the
grip to easily operate the
Recording Start/Stop
Button, Power Switch
and Power Zoom Lever.
Be sure to fasten the
velcro strip to your preference.
1
Set the Power Switch to “REC” while pressing
down the Lock Button located on the switch.
2
Make sure the LCD monitor is closed and
locked. Pull out the viewfinder fully and adjust it
manually for best viewability.
3
Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
CAUTION:
When retracting the viewfinder, take care not to
pinch your fingers.
1
Set the Power Switch
to “REC” or “PLAY” while
pressing down the Lock
Button located on the
switch.
If you are in Recording
mode, set the recording
mode to “M”. (
੬ pg. 16)
2
Open the LCD monitor
fully. ( ੬ pg. 20)
● To adjust the brightness of
the viewfinder, pull out the
viewfinder fully and set
“PRIORITY” to “FINDER”
( ੬ pg. 32 , 34) .
3
Press MENU. The Menu Screen appears.
If you are in Playback mode, please proceed to
step 5.
4
Press , , or to select “DISPLAY”,
and press SET. The DISPLAY Menu appears.
5
Press , , or to select “BRIGHT”,
and press SET. The Menu Screen closes and
the brightness control MENU appears.
6
Press or until the appropriate
brightness is reached and press SET or .
7
Press MENU. The Menu screen closes.
To attach the camcorder
to a tripod, align the
direction stud and screw
to the mounting socket
and stud hole on the
camcorder. Then tighten
the screw clockwise.
● Some tripods are not
equipped with studs.
Grip Adjustment
Viewfinder Adjustment
Dioptre Adjustment Control
Example:
Brightness Adjustment Of The
Display
Tripod Mounting
BRIGHT
MENU
GR-D650E-640E.book Page 17 Tuesday, May 30, 2006 11:31 AM