Jensen JN102 - Manual (Page 8)

-6-
JN102
Figure A
1) Make the connections to the vehicle for the 12 pin wiring harness.
2) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on
the main PCB and into the Mini-Din Connector on the main PCB.
3) Pull the wire tie loop tight and cut off the excess.
4) Connect the 12 pin harness to the mating connector on the Video Monitor.
5) Connect power harness to vehicle’s electrical system by tapping into an accessory hot line and a
good ground.
6) Verify all functions of the System before final mounting of the finished assembly.
7) Mount and connect the Television antenna. (Optional)
Note: A VCP or other A/V Component can be connected to the video monitor system using a second
source component harness (purchased separately, part number: 8010730). This harness would plug
into the Mini-Din connector on the main PCB as in steps 2 and 3 above.
A/V Source Definitions:
1= AV1, VCP or VCP with TV Tuner (Mini-Din on main PCB)
2= AUX-IN (VCP, Game or future DVD etc...)
3= Built-in DVD
4= TV (TV Tuner)
TV
ANTENNA
UNIT (BACK VIEW)
To TV Antenna In
Red RCA (Audio Right)
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Yellow RCA (Video)
White RCA (Audio Left)
"Y" Adapter
for use with
Non-Stereo
Installations
Item# 5 Power Connector
4 Pin
Accessory
Harness - Optional
(P/N:8010730) Dome Light
Power Source
CHOKE
Auxillary
video display
12 VDC Power and Ground
INPUT
VIDEO
(Yellow) Line Out-R (Red)
LINE
OUT
VIDEO Patch Cord
RCA-Female
RCA Male to Male
Line Out-L (White)
Line Out-V (Yellow)
To Secondary AV Monitor
Power Harness
Item #3
Power Harness
Item #3
OPTIONAL
TV
ANTENNA
UNIT (BACK VIEW)
To TV Antenna In
Red RCA (Audio Right)
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Yellow RCA (Video)
White RCA (Audio Left)
"Y" Adapter
for use with
Non-Stereo
Installations
Item# 5 Power Connector
4 Pin
Accessory
Harness - Optional
(P/N:8010730) Dome Light
Power Source
CHOKE
Auxillary
video display
12 VDC Power and Ground
INPUT
VIDEO
(Yellow) Line Out-R (Red)
LINE
OUT
VIDEO Patch Cord
RCA-Female
RCA Male to Male
Line Out-L (White)
Line Out-V (Yellow)
To Secondary AV Monitor
Power Harness
Item #3
PODTVT
Item #3
OPTIONAL
* OPTIONAL RELAY BOX
TO
OPTIONAL
ADDITIONAL
MONITOR
TO
OPTIONAL
ADDITIONAL
MONITOR
TO
OPTIONAL
ADDITIONAL
MONITOR
TO
OPTIONAL
ADDITIONAL
MONITOR
*
ANTENNA FOR WIRELESS FM MOD
SIRSWB
** See Antenna Note Below
*NOTE: If the original relay box P/N SIRSWB is installed, it recommended that the antenna for the
wireless FM Modulator be unplugged. See Figure A for antenna location.
**
NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM Modulator to exceed
FCC limits for wireless transmission. When installing the unit position the antenna for best
reception.
OPTIONAL