JVC KD-R311 - Manual (Page 10)

10 ENGLISH
Listening to the USB device
(For KD-R412/KD-R411/KD-R35)
This unit can play MP3/WMA tracks stored in a USB device.
~
] Turn on the
power.
Ÿ
All tracks will be played repeatedly until you change the
source or detach the USB device.
If a USB device has been attached...
Pressing / SOURCE turns on the power and
playback starts from where it has been stopped
previously.
• If a different USB device is currently attached,
playback starts from the beginning.
Stopping playback and detaching
the USB device
Straightly pull it out from the unit.
“NO USB” appears. Press / SOURCE to listen to
another playback source.
You can operate the USB device in the same
way you operate the files on a disc.
Caution on volume setting:
USB devices produce very little noise compared
with other sources. Lower the volume before
playing a USB to avoid damaging the speakers
by sudden increase of the output level.
Cautions:
• Avoid using the USB device if it might hinder
your safety driving.
• Do not pull out and attach the USB device
repeatedly while “READING” is shown on the
display.
• Do not start the car engine if a USB device is
connected.
• This unit may not be able to play the files
depending on the type of USB device.
• Operation and power supply may not work as
intended for some USB devices.
• You cannot connect a computer to the USB
input terminal of the unit.
• Make sure all important data has been backed
up to avoid losing the data.
• Do not leave a USB device in the car, expose
to direct sunlight, or high temperature to
avoid deformation or cause damages to the
device.
• Some USB devices may not work immediately
after attaching USB device or turn on the
power.
• For more details about USB operations, see
page 19.
USB input jack
USB memory
EN10-17_KD-R412_003A_f.indd 10 EN10-17_KD-R412_003A_f.indd 10 10/15/09 2:29:43 PM 10/15/09 2:29:43 PM