JVC DR-MH20B - Manual (Page 67)

Masterpage:Right0
EN
67
Filename [DR-MH30EU_09Editing.fm]
Page 67 Thursday, 3 June 2004 10:46
SYSTEM CONNECTIONS
Simple Connections
Connect the satellite receiver to the L-2 IN/DECODER connector,
then connect the L-1 IN/OUT connector to the TV’s connector.
NOTES:
● Set “L-2 SELECT” to “VIDEO” or “S-VIDEO”. ( ੬ pg. 63)
● You can use the Automatic Satellite Programme Recording function
(
੬ pg. 50) with this connection.
● To record a programme via the satellite receiver, select L-2 mode by
pressing PR +/– so that “L-2” appears on the front display panel.
● For details, refer to the instruction manual of the satellite receiver.
Connecting To A Satellite Receiver
IMPORTANT
When you set “L-2 SELECT” to “SAT VIDEO” or “SAT S-VIDEO”
(
੬ pg. 63), it is possible to view a satellite broadcast with the TV
set to its AV mode even if the unit is turned off. When the unit is
in Stop mode or recording, press TV AV/VIDEO on the remote
control to turn off the VIDEO lamp on the unit.
● If you turn on the unit when the satellite receiver’s power is off,
nothing appears on the TV screen. In this case, turn on the satellite
receiver, or set the TV to its TV mode, or press TV AV/VIDEO on
the remote control to set the unit to the AV mode.
Outdoor unit
Satellite cable
Satellite receiver
Aerial
TV aerial cable
TV
ANTENNA OUT
ANTENNA IN
DR-MH30EU_00.book Page 67 Thursday, June 3, 2004 11:00 AM