John Lewis JLBIUCF 01 - Manual (Page 10)

10
B
4
1
5. Screw appliance into place and retain the cabinet
with screws (I) through the securing brackets into
the worktop or adjacent woodwork as necessary.
If necessary, pads (E) are supplied for the rear feet to
make sliding the appliance in and out of the recess
easier.To fit the pads, press them onto the rear feet.
If required, the dimensions of these pads can be
reduced by breaking them where marked.
4. The joint cover (B) is to be assembled after having
installed the appliance in the recess.
2. Push the appliance into place.The plug socket
necessary for connection of the appliance to the
electricity supply should be positioned, so that the
plug is not placed in the recess.
3. To adjust the height proceed as follows:
- Loosen or tighten the two front feet.
- The rear feet are adjusted by turning the screw
in the front kick plate to the left or right.
596
555
max
+
-
3
+
-
E
b)
II52
E
5
I
6. To mount the furniture door proceed as shown in
the figures:
a
b
10
1
2
3
4
C
6